Portfolio
Contact Us

Molto Precise Machining Co.,Ltd

Mobile:+86 18574307389

Email:tony@moltomachining.com

Add:Building A, No. 6 Furong Street, 3rd Industrial Area, Xiagang Community,ChangAn Town,Dongguan,China.

Home > Portfolio > Content

attention in processing non-standard parts

Molto Precise Machining Co.,Ltd | Updated: Dec 25, 2018

What should be paid attention to when processing non-standard parts?


1. The abrasive grain size for grinding should be from coarse to fine and replaced sequentially. When replacing the abrasive, the grinding marks of the previous process should be completely removed, and the grinding should be carried out until only the grinding marks can be seen. It is very important to prevent the embossing phenomenon.




2. The same lap can only use the same size of abrasive. Before changing the particle size, the workpiece must be thoroughly cleaned to prevent the coarser abrasive grains or other dirt from being carried to the next process, resulting in scratching of the grinding surface. .




3. Whenever the next particle size is converted, it should be ground at an angle of 30-45° with the last grinding direction. If there is a deep scar, it is not possible to grind only the local position. Otherwise, the local position will be pitted, and the whole pit should be completely trimmed to remove the pit. Need to pay attention to uniform grinding for stations that are easy to grind and not easy to grind


attention in processing non-standard parts


Contact Us
Molto Precise Machining Co.,Ltd
Tel: Mobile: +8618574307389
Address: Building A, No. 6 Furong Street, 3rd Industrial Area, Xiagang Community,ChangAn Town,Dongguan,China.
Newsletter
Sign Up For Exclusive Updates
Get the latest special offers and discount information sent to your email address.
Copyright © Molto Precise Machining Co.,Ltd All rights reserved.